LumberJocks

Reviews: Miter Saws

  • Advertise with us
Makita LS1214F 12-Inch Dual Bevel Sliding Compound Miter Saw

Makita LS1214F 12-Inch Dual Bevel Sliding Compound Miter Saw

01-24-2009 04:57 AM by ND2ELK | 13 comments »

I just bought this Makita 12” sliding miter saw and cannot say enough good about this saw. I went to Acme Tool an hour and a half away in Cedar Rapids so I could play with the Makita, Bosch and Dewalt miter saws. I felt the Makita had the smoothest slides of all three and liked the way the slides are on the bottom of the saw. There was no movment whatsoever and it just seemed like the best quality saw. It was right on the nuts out of the box and I cut all my trim for the shop with it. I would...

Read this review »


Old Reliable

Old Reliable

01-25-2011 06:55 AM by devann | 9 comments »

This review is for a saw that I’ve been using almost daily for a little over four years now. I purchased the DW718 after using the DW708 for over nine years. Out of the box I noticed that the base had grown a bit, but still had 110 degrees of miter settings and the same simple to adjust detent plate. I found this to be a plus after witnessing what some of my peers experienced while reclibrating some of the other manufactures mitersaws. From my experience the only time I’ve had an...

Read this review »


This Saw is SWEET

This Saw is SWEET

10-31-2010 02:21 AM by sarquis | 17 comments »

Hello All,New to posting on Lumberjocks, Hope to be doing alot more.Picked up the new Bosch Axial Glide Miter Saw today. This thing is AMAZING. I really enjoyed my 12” Ridgid Sliding saw. Never had any complaints about it. But this bosch is a whole different animalIt is so smooth. i just started playing with it today.I will be posting a in depth review in a about a week or so.If anyone else has one, could you post some feedback, reviews, insight, etc.ThanksJiam from NJ PS Going to be...

Read this review »


Makita LS1016L 10" Dual Slide Compound Miter Saw w/ Laser

Makita LS1016L 10" Dual Slide Compound Miter Saw w/ Laser

08-05-2010 09:59 PM by GregP | 10 comments »

So I just got this miter saw about a month ago and so far the only complaints I have had about it where that I needed to adjust the laser after I first got it. It cuts smoothly and accurately, it slides nicely and it makes cuts up to 13” wide. it’s already saved me lots of time, I hardly need to use my crosscut sled anymore for anything other than plywood and I just can’t say enough good things about this saw!

Read this review »


Very good saw for a variety of uses

Very good saw for a variety of uses

05-15-2009 01:54 PM by jonah | 4 comments »

My wife and I bought a house two years ago, and planned to redo the kitchen pretty extensively. I grew up doing construction projects with my step-father and am able to do framing, drywall, finish work, electrical, and very basic plumbing on my own. We ended up tearing it down to the studs and starting from scratch, and did 99% of the project ourselves. I realized before we started that I was going to need more power tools. I had a drill, jigsaw, circular saw, and hand tools, but had no sp...

Read this review »


Fantastic saw for rough or finish work

Fantastic saw for rough or finish work

02-03-2010 06:15 AM by wannabe | 13 comments »

Hi all, Since I’ve read so much good advice, I thought I’d contribute a little myself. I’ve had the C10FSH for a couple of years now and have to say it is hands down a fantastic saw. It’s a dual bevel 10 inch slider that I bought so I could cut some boards to lay under a shed. I’ve also used it for some fine trim work and hope to use it for some furniture building. It is dead-on accurate and doesn’t need to be readjusted unless you change the blade. ...

Read this review »


Makita LS1016L Sliding Mitersaw

Makita LS1016L Sliding Mitersaw

04-18-2010 04:00 PM by Cato | 21 comments »

I bought this saw a few months back because I needed better accuracy than my old RAS could deliver consistently. I did a bit of research comparing models, prices, sizes, and I liked the feel and action of this saw the best, as I didn’t really want or need a 12 inch miter saw if I could get one in the 10 inch range that could cut a dimensional 4×4 if need be. After using it for crosscuts, bevels and miters over the past few months I can say that I am really happy with my p...

Read this review »


Milwaukee 12-in Dual-Bevel Compound Miter Saw

Milwaukee 12-in Dual-Bevel Compound Miter Saw

07-06-2010 04:49 AM by POGO | 6 comments »

After 10 years of reliable service, I decided to update my Miter Saw station (i.e. bench with a single bevel DeWalt miter saw sitting on top). My decision was based my son now having a workshop where I could “will” him tools which could stimulate his interest in woodworking. This would give me a good excuse to upgrade to a miter saw which has been designed to capture the saw dust from the cut. I do not have the funds for a Kapex, which has been touted as the gold standard for miter saws,...

Read this review »


Great Sliding Compound Miter Saw for Woodworkers on a Budget

Great Sliding Compound Miter Saw for Woodworkers on a Budget

10-06-2010 08:00 PM by PocketHole69 | 10 comments »

I’ve had an old Ryobi $99 Home Depot special miter saw for years and was looking to upgrade to a sliding model for wider cut capacity. I really wanted a laser too, because lasers are awesome. I did a lot of searching on Amazon and at the usual woodworking sites and pretty much resigned myself to spending $400-500 for a decent sliding compound miter saw from Milwaukee or Dewalt and started saving money. That was until I walked through the tool section at Lowes and noticed their ne...

Read this review »


One Sweet Saw

One Sweet Saw

03-07-2011 05:41 AM by Don | 22 comments »

Cuts very clean. The 90 degree stops were perfectly square right out of the box so no adjustment needed. With a dust collector attached it’s got excellent dust control. It glides so smooth you can just about operate it with a couple fingers. My only gripe is that it did not come with a laser guide. Even my $90 Makita P.O.S. came with one. For an $800 saw to not have one is mind boggling. I was so annoyed by that I almost gave it 4 stars.

Read this review »


1 2 3 4 ... 8 next »
79 reviews

Add new review
View Product Index
RSS FEED

Browse reviews

categories | brands | all reviews


DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com

Latest Projects | Latest Blog Entries | Latest Forum Topics

GardenTenders.com :: gardening showcase