LumberJocks

All Replies on Finding Antique Plane Irons

  • Advertise with us
View Bluenote38's profile

Finding Antique Plane Irons

by Bluenote38
posted 08-18-2017 10:48 AM


4 replies so far

View EricTwice's profile

EricTwice

237 posts in 615 days


#1 posted 08-18-2017 12:20 PM

those wooden planes were generally hand made and the cutter was custom to the unit. If it needs a blade, you will need to make one.

If it were me I would start with a file, and put it in the oven at 450 Degrees F. for half an hour. This will give it the correct temper. (files are too brittle to use without retempering.)It will be a light yellow brown when you are done. (straw) It should be about about Rc 63. it will not file well. but will hold an edge and be less likely to chip.
Then I would sand top and bottom to remove the teeth, after that, grind it to shape

-- nice recovery, They should pay extra for that mistake, Eric E.

View Bluenote38's profile

Bluenote38

295 posts in 470 days


#2 posted 08-18-2017 12:23 PM



those wooden planes were generally hand made and the cutter was custom to the unit. If it needs a blade, you will need to make one.

- EricTwice

I was afraid that might be the case. Any idea what the blade looks like?

-- Bill - Rochester MI

View knockknock's profile

knockknock

450 posts in 2255 days


#3 posted 08-19-2017 04:08 PM

... Any idea what the blade looks like?
- Bluenote38

From your description, it sounds like your knicker blade may be like the one in this discussion:

http://www.woodcentral.com/woodworking/forum/archives_handtools.pl/bid/3106/md/read/id/84672/sbj/wooden-dado-plane-build-question/

Edit: I forgot to add: If the blade is like that, you might be able to make it out of a blank from Lie-Nielsen:

https://www.lie-nielsen.com/nodes/4142/tapered-molding-plane-iron-blanks

-- 👀 --

View Bluenote38's profile

Bluenote38

295 posts in 470 days


#4 posted 08-19-2017 09:46 PM



... Any idea what the blade looks like?
- Bluenote38

From your description, it sounds like your knicker blade may be like the one in this discussion:

http://www.woodcentral.com/woodworking/forum/archives_handtools.pl/bid/3106/md/read/id/84672/sbj/wooden-dado-plane-build-question/

Edit: I forgot to add: If the blade is like that, you might be able to make it out of a blank from Lie-Nielsen:

https://www.lie-nielsen.com/nodes/4142/tapered-molding-plane-iron-blanks

- knockknock

Looks perfect – I just need to scale it for a 1/2” I’ll check LN thanks.

-- Bill - Rochester MI

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com