LumberJocks

All Replies on How to cut a dado for a bottom panel when one side of the box is angled?

  • Advertise with us
View Dagobah's profile

How to cut a dado for a bottom panel when one side of the box is angled?

by Dagobah
posted 08-14-2017 05:17 PM


6 replies so far

View EarlS's profile

EarlS

1030 posts in 2345 days


#1 posted 08-14-2017 05:23 PM

If you cut the bottom panel edge at 18 deg to match the angled side then measure the length of the cut you should be able to set a dado for the side piece that will match the angled cut on the bottom piece. Hopefully my explanation makes sense.

-- Earl "I'm a pessamist - generally that increases the chance that things will turn out better than expected"

View Woodknack's profile

Woodknack

11619 posts in 2377 days


#2 posted 08-14-2017 05:28 PM

Cut the dado at an angle, unless I’m misunderstanding.

-- Rick M, http://thewoodknack.blogspot.com/

View Loren's profile

Loren

10384 posts in 3645 days


#3 posted 08-14-2017 05:31 PM

If the bottom rim of the box is flat you
can dry-assemble it and cut a groove
for the bottom on a router table with
a bearing guided 1/4” slotting bit. The
corners of the groove can be squared
up with a chisel. The groove in the
angled end will also be shallower unless
you switch bearings.

View Ocelot's profile

Ocelot

1975 posts in 2635 days


#4 posted 08-14-2017 05:47 PM

Why not just tilt the blade on the table saw. single pass with Dado stack. do a test on scrap first. Am I missing something?

View Dagobah's profile

Dagobah

71 posts in 660 days


#5 posted 08-14-2017 06:26 PM

Hah! I hadn’t even thought to use the table saw!

I’d been planning on using the router table to make all the dados, as two of them need to be stopped (the box needs to be joined using butt joints). But the angled piece will have it’s edges hidden, so the table saw will work. I’ll just need to make a few test cuts on scrap to make sure the router cut dados match up to the table saw cut ones.

Thanks!

View MrRon's profile

MrRon

4764 posts in 3240 days


#6 posted 08-14-2017 06:36 PM

Cut the dado at the 18° angle and bevel the bottom panel 18°.

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com