All Replies on Table saw blade won't go back to 90 degrees

  • Advertise with us
View MikeDe's profile

Table saw blade won't go back to 90 degrees

by MikeDe
posted 02-18-2017 07:18 PM

7 replies so far

View cutmantom's profile


401 posts in 2938 days

#1 posted 02-18-2017 07:34 PM

Definitely check for sawdust buildup or a stray piece of wood offcut, is the bevel still clamp released, it might tighten up as you turn the hand wheel, also is the 90 degree stop secure or has it move due to vibration
Just my 2cents

View waho6o9's profile (online now)


8099 posts in 2480 days

#2 posted 02-18-2017 07:37 PM

Unplug it and clean out the insides.

View alittleoff's profile


534 posts in 1180 days

#3 posted 02-18-2017 08:20 PM

If cleaning don’t work, check the bolt that stops the blade. It will be located at the end of travel, you can’t miss it.

View WhyMe's profile


979 posts in 1464 days

#4 posted 02-18-2017 08:36 PM

This may sound like a Duh thing but make sure the lock knob is not tightening as you spin the crank.

View BurlyBob's profile


5242 posts in 2169 days

#5 posted 02-18-2017 09:15 PM

I had the same problem with my Delta x5. Cleaning definitely helped moving the blade but like Gerald said adjusting that bolt at the end of the travel was the game changer.

View ChrisPall's profile


1 post in 218 days

#6 posted 07-16-2017 11:48 AM

Good morning! Did anything work?

View woodbutcherbynight's profile


3937 posts in 2312 days

#7 posted 07-16-2017 01:41 PM

Had same problem recently, cleaned out the chamber with the blade and found sawdust compacted on top of the stop . Works great now, added checking this to my monthly routine.

-- Live to tell the stories, they sound better that way.

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics