LumberJocks

All Replies on Help needed

  • Advertise with us
View Ianss's profile

Help needed

by Ianss
posted 12-02-2016 08:02 PM


4 replies so far

View HokieKen's profile

HokieKen

5828 posts in 1220 days


#1 posted 12-02-2016 08:13 PM

Good chance your pulley is just corroded in place. Soak the heck out of it with some penetrating oil and see if it loosens up. While you may not be able to find a direct replacement, there’s a good chance you can find one the same size online.

Will need some pics to aid further since I’m not familiar with that lathe.

-- Kenny, SW VA, Go Hokies!!!

View Devok's profile

Devok

5 posts in 625 days


#2 posted 12-03-2016 06:23 PM

If you haven’t seen it, here is a link to the original manual that came with the 101.06242. Might be of some help to you. Otherwise, I agree with Kenny that some penetrating oil will probably free the pulley from the spindle. Provided you’ve already removed the set screws of course.

http://vintagemachinery.org/pubs/detail.aspx?id=1766

View MrUnix's profile (online now)

MrUnix

6845 posts in 2281 days


#3 posted 12-03-2016 06:40 PM

Spindle comes out towards the tailstock (to the right when looking at it from the front). You will need to loosen the collar(s) and set screw in the pulley if there is one. Once loose, try tapping on the outboard side of the spindle with a wooden mallet or soft blow hammer. A puller can also be made using some all-thread, a couple of fender washers and two nuts – but hopefully, it will break loose with a few taps, making that unnecessary.

Parts might be a bit hard to find. Might want to go ask over at OWWM check the classified section.

Cheers,
Brad

-- Brad in FL - In Dog I trust... everything else is questionable

View Ianss's profile

Ianss

2 posts in 623 days


#4 posted 12-04-2016 01:28 PM

Thank you for the help, the pulley eventually did come off with a lot of effort, the catalog helps too now to find some parts on the web.

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com