All Replies on How would you make these grooves?

  • Advertise with us
View trevor7428's profile

How would you make these grooves?

by trevor7428
posted 10-06-2016 12:34 AM

5 replies so far

View cabmaker's profile


1744 posts in 3047 days

#1 posted 10-06-2016 12:36 AM

dado stack on a tablesaw would make short order of it.

View waho6o9's profile


8539 posts in 2815 days

#2 posted 10-06-2016 01:49 AM

What cabmaker said ^^^^

Maybe a router jig with a base would work.

View JBrow's profile


1366 posts in 1158 days

#3 posted 10-06-2016 02:01 AM


The easiest way is as cabmaker suggested, tilting a dado stack and make bevels grooves. But in my shop, that would leave score marks of the bottom of the grooves requiring a lot of hand sanding to remove.

An alternative is to use the router table and a straight bit. The first step would be to face glue a sacrificial board to the workpiece. Once the pieces are glued together, a beveled re-saw cut could be made through the sacrificial piece, leaving the workpiece intact.

The second step would be to flip the workpiece over so that the beveled sacrificial face is resting on the router table. The router fence and the height of the router bit are set so that the groove is at the desired depth and location in the workpiece. The groove would run all the way through the sacrificial piece and into the workpiece. The fence and router bit height are readjusted for subsequent grooves.

The last step is to re-saw the sacrificial piece free from the workpiece.

View scribble's profile


204 posts in 2438 days

#4 posted 10-06-2016 04:27 PM

Instead of gluing it would carpet tape to secure just make sure your layout is not in the tape to gum up the bit?

-- If you can't read it Scribble wrote it!! “Experience is merely the name men gave to their mistakes.”

View Woodknack's profile


12464 posts in 2618 days

#5 posted 10-06-2016 07:44 PM

If it’s just one, keep it simple, dado stack and clean up with a chisel. Or router on an angled sled.

-- Rick M,

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics