LumberJocks

All Replies on Should I mill these logs on the BS or buy an Alaska Mill?

  • Advertise with us
View JohnMcClure's profile

Should I mill these logs on the BS or buy an Alaska Mill?

by JohnMcClure
posted 11-28-2017 09:22 PM


2 replies so far

View Ripper70's profile

Ripper70

1085 posts in 990 days


#1 posted 11-28-2017 09:41 PM

Are you sure that band saw has the height capacity? Twelve inch diameter logs may be just on the edge of capacity for your saw. Either way, you’ve got your work cut out for you but a nice prize in the end.

-- "You know, I'm such a great driver, it's incomprehensible that they took my license away." --Vince Ricardo

View sawdustdad's profile

sawdustdad

364 posts in 967 days


#2 posted 11-29-2017 02:20 AM

Take the logs and run them over the jointer to get a flat surface first. That will give you some stability to cut them on the bandsaw. Many years ago I actually built a carriage assembly to mill logs on my Hitachi resaw. It has a 3 inch wide blade with stellite teeth and 3hp motor and 12 inch cut height.

Here’s a you tube video (not mine) of the resaw. https://www.youtube.com/watch?v=ZP-eDA51Nhk

I gave up pretty quickly as the logs were heavier than I could manage and even 3hp was not enough (IMO) to do it efficiently. Local sawmills became my source after that…

With a few cherry logs, you can do it if you are careful. The biggest risk is that you’ll roll the log due to blade forces and damage your blade and/or ego.

-- Murphy's Carpentry Corollary #3: Half of all boards cut to a specific length will be too short.

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com