Reply by stefang

  • Advertise with us

Posted on How would you gang cut these pickets?

View stefang's profile


15881 posts in 3356 days

#1 posted 06-08-2009 08:20 PM

I like a tablesaw solution best providing you can stand them vertical. I would clamp a bunch together. Two of the angles are the same from each edge. You can register the first edge against a spacer when you do the first cut, then remove the spacer and run it through again registering the same edge to cut the 2nd angled in the same direction. Then register the other edge again with the spacer inserted and do the same procedure again. Of course the blade will be set at 45 degrees.

Hope this is a little clearer than mud. Don’t hesitate to ask for clarification if your interested in this method. This is the same solution as bently but with the addition of the spacer.

-- Mike, an American living in Norway.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics