Reply by turkva

  • Advertise with us

Posted on outfeed table problem

View turkva's profile


29 posts in 3944 days

#1 posted 04-13-2009 04:37 PM

Hey SeriousTurtle, I had the exact same problem you do. I ended up nothching out my outfeed table to accomodate the swing of the motor. I can send you pictures later, unfrtunately I am at work right now (Obviously not getting too much work done!). It eneded up being a notch approximately 6 – 8 inches long and about 6 inches wide. This isn’t a Rigid tablesaw is it? Hope this helps.

-- Accept Nothing, Challenge Everything

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics