Reply by Charlie

  • Advertise with us

Posted on Question about jointer fence

View Charlie's profile


1100 posts in 2281 days

#1 posted 07-08-2013 12:57 AM

OK. Not sure why I didn’t catch this before. Except that they don’t point it out anywhere in the manual that I can find. The mount for the fence was set dead even with the outfeed table. I had to raise it up. Very hard to do with the fence in place so I had to remove/reinstall several times until I got it really close to where I wanted it, snug up the bolts, set the fence to check it had stayed put, tighten a little more, remove fence and finally tighten the bolts. Fortunately, I don’t see this as something that will need to be done again :)

And basically, they set it wrong at the factory. No big surprise there I suppose. I usually go through everything anyways.

Thanks, guys.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics