Reply by RonInOhio

  • Advertise with us

Posted on Drill press bit wander issue..

View RonInOhio's profile


721 posts in 2889 days

#1 posted 06-23-2013 10:12 PM

I agree with the table likely not being flat. If the table checks out, remove the chuck and clean the
shaft and inspect. Check for burrs on any of the surfaces. Clean well and then put the assembly back

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics