Reply by Airframer

  • Advertise with us

Posted on Drill press bit wander issue..

View Airframer's profile


3043 posts in 1976 days

#1 posted 06-23-2013 06:30 PM

Basically any hole I try to drill in anything be it red oak or pine the hole will be 1/8” to 1/4” off from center on the back side. I had though bit flex but like I said my 1” bits will do the same thing. Is it possible it is an issue with table flex? That is just about the last thing I can think of to check.

-- Eric - "I'm getting proficient with these hand jobbers. - BigRedKnothead"

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics