LumberJocks Woodworking Forum banner

Moisture Meters

2K views 9 replies 9 participants last post by  jimp 
#1 · (Edited by Moderator)
So hey, what's a good moisture meter? There's bunches of em listed from pocket change all the way to the price of a good tool. Anyone have experience/suggestions?
 
#2 ·
I have the Wagner L609 and it works well. It runs about $190.

But to tell the truth I really don't know what to do with it. I have no control over the moisture content of the lumber I am using. Lumber will reach equilibrium with ambient conditions so while I can get a reading of the moisture content on any given day I can't change the moisture level that is in the wood. I can see where it would be helpful if I was drying my own wood but I buy kiln dried rough lumber that is in the 6-8% range.
Within a short period of time it usually ends up in the 10-12% range when I store it in my shop. So I either use it as is or wait for the moisture content to change which will never reach the levels when it came from the kiln.

I guess I look on it more as a novelty item than an essential woodworking tool.
 
#4 ·
I have the Lignomat set…a bit spendy…but it's been well worth the investment considering I dry my wood the old fashioned air method…just after the tree is downed I've had readings in the 20s…then over a period of months it falls…the maple I have out back is now in the 8 to 10 per cent range…some now in my garage…and I haven't taken the percentage since I brought it in…but Lignomat is the answer…I have both capabilities…the separate fork and the smaller built in tines. Whatever system you buy, it'll save some headaches and worry about when your wood is ready to use. Also…a magnetometer is important…to be certain there are no bullets or nails in the wood…especially if you're getting trees that have fallen (and can't get up, haha) or you're harvesting in a forest or on someone's private property. Both investments assure the woodworker the wood is usable. Recently, I heard a story about a 30 inch walnut trunk…about 10 foot long…brought to South Dakota from Minnesota. The woodworker thought he'd gotten a great bargain. Well, the tree was full of bullets and the sawyer just left it on his property to serve as a warning to others.
 
#9 ·
Gary, you live in Texas, for cryin' out loud! The drinking water here is only about 85% moisture. I have a moisture meter and I usually have to hose down the lumber to get it to even register. Air dried lumber takes on a whole new meaning here, ya know. What takes 2 or 3 years in the rest of the country, only takes 2 or 3 months in the summer here in Texas. I think Roman has the right idea, just check a shaving or some saw dust.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top