Reply by BuckeyeNate

  • Advertise with us

Posted on Jointer Set up Issues / Question

View BuckeyeNate's profile


9 posts in 2010 days

#1 posted 04-15-2013 02:32 AM

Picklehead: I took a pic where i measured from:

From the right most part of the infeed i get about 6 1/2 and 5 7/8” on the outfeed as left most as possible, the fence is only 29”!!! Man the most i look into this the worse off it gets….

Also, weird thing…I measured with my calipers the two bolts you pointed to with the spring clamp and they both were with in a few thou. I think one was .669 (infeed) and .659 (outfeed). Would a difference in 10 thou affect the angle of the fence that drasticly? So thinking about this logically, the bolt that was “shorter” would be pushing the table out…which does support my situation….hmmm….


The locating key is a little twisted, but the picture makes it look worse than it truly is. Tomorrow after work, i will tear into the fence shelve and mating surface. I’ll take some pictures to get everyone’s input…..stay tuned.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics