LumberJocks

Reply by BuckeyeNate

  • Advertise with us

Posted on Jointer Set up Issues / Question

View BuckeyeNate's profile

BuckeyeNate

9 posts in 1767 days


#1 posted 04-14-2013 07:01 PM

So i went to check out the shelve and mine was off quite a bit:

I didnt feel like adding all these up, but as you can see….there was quite a gap:

I took a look at the fence locating key, everything appears to be ok, i took the entire fence off and when i put it back it appeared to be the same.

I ended up loosening the two bolts that attached the shelve to the jointer “body” and fine tuned it a bit. I ended up cutting the gap above to about half of whats shown.

Is this how everyone’s jointer like this and i just never noticed? The point is to square a face or two on a board, so if the fence is out of whack a bit, i dont think its the end of the world as long as its close to 90 degrees as possible to the beds.


DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com