LumberJocks

Reply by mbs

  • Advertise with us

Posted on Trouble Cross-Cutting 1.5 thick maple

View mbs's profile

mbs

1437 posts in 1592 days


#1 posted 01-15-2013 02:38 PM

Can you clean it up with a plane with a very sharp iron? or an edge sander?

I think a router bit would be worse.

I have cleaned up end grain with a jointer too. Very, very light pass, very slow feed rate and tape the end so you don’t get tear out. If you’re going to round the corners you can do it first and not worry about tear out.

Not sure if it’s your blade, saw or setup. A saw with some vibration will do that even with a good blade. I don’t think my festool would be perfect but I’m sure it would be better than the results you’re showing.

-- Sorry the reply is so long. I didn't have time to write a short reply.


DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com

Latest Projects | Latest Blog Entries | Latest Forum Topics

GardenTenders.com :: gardening showcase