LumberJocks

Reply by teejk

  • Advertise with us

Posted on Need a setup for cutting sheet goods

View teejk's profile

teejk

1215 posts in 1407 days


#1 posted 01-02-2013 08:50 PM

I personally can’t handle 1/2” or larger sheets on my TS…not the least of my issues is the “off” switch is 6’ away…but I can’t justify a panel cutter either.

do you have the room for a permanent 4×8 table (I did and I use it all the time for layout, assembly, layout, “junk”)? If so then use that for big panel breakdowns (a minimum of 4 1” stickers” to support the cuts with a circ saw set to not cut into the table top). I have short arms and can’t complete a cut across a 4” span so I shut it down and finish from the back side in a “pull operation”.

remember “good side” down for circ saw cuts. and as noted above, cut a bit wide and get your finished dimensions once the panels are managable.


DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com

Latest Projects | Latest Blog Entries | Latest Forum Topics

GardenTenders.com :: gardening showcase