Reply by patron

  • Advertise with us

Posted on planer problems

View patron's profile


13604 posts in 3341 days

#1 posted 12-24-2012 11:16 PM

i’m guessing the sap is on the table
and is keeping the boards from sliding through
and the rubber rollers are spining on the boards
and leaving their mark

raise the cutter head
and wipe the table with a solvent
(maybe mineral spirits or lacquer thinner
if not plastic close there)

then wax good

this should help

watch the blades as you clean under them

-- david - only thru kindness can this world be whole . If we don't succeed we run the risk of failure. Dan Quayle

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics