While the sapwood of Cherry IS white and DO I see it crossing the outside corners of the Cherry, there also appears to be white smudges in the photo that looks like glue stains to me. It even appears to smudge across a couple different wood species there if I am seeing it correctly. (Could be light in the camera lens - hard to tell exactly)
End grain is quite porous, so the glue can really go deep. You may be sanding quite a bit to get these out.
Ok. thanks for the feedback. I thought I had selected boards with no sapwood but apparently I must have missed that little bit of sapwood on the side of one cherry board..
Yes, I am going to sand more. That other smudge is probably glue. Each time I glue up a cutting board, I have glue flying everywhere in the heat of the moment of trying to quickly glue up 24 strips. Still have to figure out the optimal way..
You may have selected boards with no visible sap wood, but once you cut into them it was there. Look at the walnut cutting board below. I didn't see the sapwood until I planed the glued up cutting board. It was visible on the other side of the board, but I had done the glue up so one side would be all dark wood, but that didn't work out.
You might be able to fix that sap wood with a little Gel Stain and a Q-tip. At least make it more defined against the sap wood. I'd tape the sapwood first. The other looks like a bit of glue or something. I'd try a piece of 180 by hand and see if it sands out. Go easy.
Yves, you might try gluing up in two stages to help take off some pressure during the glue up.
Half as many strips at a time, then glue two halves together.
There is a practical limit to how much glue one can sling about at a time before joints begin to fail.
I think I am worst when it comes to glue slinging.
Iguana I didn't mean to imply there was anything wrong with it. It actually sold for a nice price. I was just pointing out to the original poster here that the sap wood only showed up after I planed and sanded the board. He was saying basically the same thing happened to him as the sapwood wasn't visible when he selected the boards for his cutting board.
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
LumberJocks Woodworking Forum
2.5M posts
96.9K members
Since 2006
A forum community dedicated to professional woodworkers and enthusiasts. Come join the discussion about shop safety, wood, carpentry, lumber, finishing, tools, machinery, woodworking related topics, styles, scales, reviews, accessories, classifieds, and more!