Posted on Router table top isn't flat. Need some advise.
|
#1 posted 185 days ago |
JJ, it’s .012” out and it’s worst area right over the bit. The picture shows the angle iron reinforcement below the table. there is about 11” between angle iron where the router is located and 8” between angle iron to the right of the blue dust collection box. The dust collection box is in the way of reinforcing the area around the router (unless I cut the box). It acts like the router has sucked the table down in the center between the angle iron. The table top slopes off drastically on the left side of the miter slot where there isn’t any support..
-- Sorry the reply is so long. I didn't have time to write a short reply. |
