Reply by sixstring

  • Advertise with us

Posted on Dados in table saw

View sixstring's profile


296 posts in 2267 days

#1 posted 11-05-2012 10:17 PM

or warped wood. was the board surfaced properly? had the same problem cutting dados across some material and it turned out that the wood (which looked dead straight) had a slight upturn which casue my dados to be almost a full 1/8” shallower at one end.

point is… make sure the wood is dead straight and hope it isnt the table.

-- JC Garcia, Concord, CA : "It's easier to ask forgiveness than permission..."

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics