LumberJocks Woodworking Forum banner

Good Learning Experience

2K views 11 replies 10 participants last post by  SnowyRiver 
#1 · (Edited by Moderator)
I was thinking today that I wish I had a video camera in the shop. I planed two birch 4/4 boards to 3/4 by about 6 inches wide. I'm making a face frame for a large storage cabinet. As I was cutting the strips of birch, 1 1/2 inches wide for the frame, I noticed as the board passed the riving knife that there was so much tension in the wood that the saw kerf was closing so tight that I could hardly see the kerf.

If I wouldnt have had the riving knife on the saw, I probably would be picking this board out of my teeth. It would have been a good video for someone new to woodworking on the reasons to always use a riving knife or splitter.
 
#2 ·
There is a time and place for riving knives. Mine is off at the moment because I'm only using it to slice 1/8 strips off a 4×4.
Is the wood riding along the fence okay, the kerf shouldn't close up on you.
 
#3 ·
Yep, very straight along the fence…once it cleared the fence and the knife, the two pieces started to pull over against earch other. Thats why they make splitters and riving knifes to prevent a serious kick-back when this happens. I dont use the knife when I am doing dados, but after a serious kickback a few years ago I learned my lesson when ripping boards. LOL. I dont ever want that to happen again.
 
#5 ·
Glad you had your riving knife in!

You might want to think about taking those boards over to the band saw for ripping. I've taken to doing that anytime I'm ripping more than a little off of an edge to square up a board; that is at least for boards I can handle on the relatively small band saw table. I've had quite a few kerfs close up on me.
 
#6 ·
I've had this happen on maple recently. It pinches so hard on the riving knife that it becomes really hard to push. I'm afraid to just keep pushing harder for fear it's going to suddenly get easier and I'll force the wood hard into the blade. So I stop feeding, turn the saw off. Leave the board right where it is. Go around and put a wedge in the kerf just past the riving knife, walk back around and pull the board just a touch off the blade and start it back up and continue. I have actually had boards when trying to cut long 1-1/2 inch wide pieces like 6 feet long, that have the cut-off curl UP and start to cross OVER the other piece.

Wood does weird stuff. :)
 
#12 ·
Cole…I could use a riving knife on all cuts, but I would have to change it to a smaller knife. I have never had any problems with dados so I just use it on through cuts.

MNgary…yes, I was able to use the pieces. I had cut about 6 or 7 eight footers and two were curved or bowed. I cut those up and used them for the face frame on the shelves.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top