Yesterday I went and got my new Grizzly G0513X2BF bandsaw from the Springfield, Missouri, location. Today I am putting it together and mating it to the Shop Fox mobile base. Grizzly Tech Support said to put a 3/4 to 1" plywood raiser so that the bottom door will open. I can confirm that this is necessary.
I started looking to assemble and attach the fence and have two problems:
1. The cast iron fence I received (supposed to be an upgrade from their low end fence) did not come with installation instructions. The manual talks about the low end fence. I did find on the Sub-Assemblies page a diagram showing the cast iron fence and mounting hardware, but no assembly instructions.
2. There does not seem to be any hardware to mount the front rail to the table or the resaw fence to the regular fence.
I have e-mailed Grizzly and am awaiting a response (although I am not holding my breath).
Can anyone confirm whether I should have received installation instructions and hardware?
Thanks
I started looking to assemble and attach the fence and have two problems:
1. The cast iron fence I received (supposed to be an upgrade from their low end fence) did not come with installation instructions. The manual talks about the low end fence. I did find on the Sub-Assemblies page a diagram showing the cast iron fence and mounting hardware, but no assembly instructions.
2. There does not seem to be any hardware to mount the front rail to the table or the resaw fence to the regular fence.
I have e-mailed Grizzly and am awaiting a response (although I am not holding my breath).
Can anyone confirm whether I should have received installation instructions and hardware?
Thanks