Reply by bluekingfisher

The dia of the impeller is 17”. There is no Amp rating shown on the motor plate, its 240V with a 1.5Kwh rating (2HP) if that is any help.

The DC has a 6” port on the impeller housing. What I was intending to do was run a 6” hose to the seperator about 4 or 5 feet. The remainder of the duct work will be 4 1/2”

When next in the shop I’ll take a couple of photos, a picture paints a thousand words, as they say.

There will be dust hoods/collector boxes at the machines. I also have a fine filter cartridge (0.1 microns) so fine dust will be catered for.

Thanks again for your advice, much appreciated.

David

-- No one plans to fail, they just, just fail to plan