LumberJocks

Reply by Dustin

  • Advertise with us

Posted on YABF (yet another brain fart) (sigh)

View Dustin's profile

Dustin

530 posts in 769 days


#1 posted 06-14-2018 01:25 PM

I’m working on a small side/buffet table for some friends (similar to the shaker style library table Norm built on the NYW). For the front apron where there will be two drawers, I milled two narrow rails for the top and bottom, and glued in space blocks on both sides and the middle. Well, I screwed up when I measured the center point for the middle block, and ended up with one 13” wide drawer and one 15” (luckily I measured before I started cutting the stock for the drawers). Frustrating? Yes. But I ended up using my router, edge guide, speed square, and a whole lot of clenching to widen out the narrower opening by reducing the overall width of the center divider.

The worst part was is that the night before I discovered this, after I glued it up, I was thinking: “This is going too well. I’m not that good or that careful, something has to be wrong.”

-- "Ladies, if your husband says he'll get to it, he'll get to it. No need to remind him about it every 6 months."


DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com