LumberJocks Woodworking Forum banner

need help

1K views 3 replies 4 participants last post by  ChicoWoodnut 
#1 · (Edited by Moderator)
Hi,
Has anyone ever made a jig for raised panel doors using a table saw? I am re-modeling the kitchen cabinets and want to make raised panel doors.
Any ideas?
 
#3 ·
My understanding is that you need to make a tall aux fence for your saw. Set the fence 1/4 away from the blade and tilt your saw blade to 12 degrees. Make sure your fence is on the keeper side of the blade. This is for 1/2" pannels ( I am digging into my memory from one of Norms episodes it could be a 3/4" panel. The resulting tongue should fit into the 1/4" groove in the door frame.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top