LumberJocks Woodworking Forum banner

Cypress, What kind of finish?

10K views 10 replies 8 participants last post by  Blackie_ 
#1 · (Edited by Moderator)
I am about to install a room wrap wall to wall shelving, wood choice is Cypress, it will have a rear wall support and a front support to keep it from sagging, It will be up high maybe a foot off of the ceiling so only the bottom of the shelving boards will be visiable, should I go ahead and finish both sides? Also need to know what kind of finish would work best, was hoping for some ideas, I want the natural beauty of the of the wood to show without changing the color to much, if anything just making it stand out more, also if possible something that doesn't take long to dry.

The Pic shown here is an Oak shelving unit, not mine just showing the design I will be using.

Bookcase Shelf Book Wood Publication


Thanks

Randy
aka Blackie
 

Attachments

See less See more
2
#2 ·
I think you should finish both sides. I think BLO before a clear would help bring out the grain, but, that would take a day or more, depending how quickly the Cypress absorbs it. I too, am curious as what others will say and/or suggest. Look forward to seein the finished shelves
 
#5 ·
Ok so pure Lacquer seems great to me, what about Tung oil I've used Lacquer over it before with success but I do think it takes a day for drying. What about the natural oil that is in Cyperss would I need to cure this?
 
#6 · (Edited by Moderator)
I have worked alot with cypress and used numerous finishes over the years. Cypress is a wood with natural oily resins in it…which make it very resistant to decay.
I have found the following results:
Drying time varies considerable depeending if it is new growth cypress, old cypress or sinker cypress.
A polyurethane finish is the most durable but sometimes the first coat will take 3 - 4 days to dry.
Tung Oil …any finish with an oil base will dry very slowly.
Water based finish will also dry quickly and allow numerous coats…. and not leave a lingering smell for days that polyurrethane or lacquer leaves. Does not really bring out the beauty of the woodgrain.
Lacquer… dries extremely fast and you can spray numerous additional coats in a day. I use lacquer on the boxes I build and really like the appearance. Looks especially good if you buff with steel wool.
 
#9 · (Edited by Moderator)
Go to Lowes and get you some Deft Lacquer. Says brushing lacquer on the can because of VOC regulators.
It can be brushed or sprayed. Deft is some of the finest lacquer on the market.
Dries fast. When we use it we can usually get three or four coats a day. Sand with fine paper between coats for a more deep looking finish.

Dust the first coat on to raise the grain and let it dry…sand and then keep going. We thin about 10%.

As a matter of fact, we're getting ready to use the Deft Semi Gloss on a large set of Cherry kitchen cabinets and will put 5 coats lightly sanding between coats. Will be completed in less than 2 days.

We've sprayed loads of Deft on Cypress. Deft is very user friendly.
 
#11 ·
Marty I never dust LOL but as I type this and think about it, the shelfs will be for my bandsaw boxs as I'm running out of room to store them which are also my pride and joy so I might make an exception in this case LOL go get me one of those swifter duster thingys hahaha.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top