LumberJocks

Reply by Mainiac Matt

  • Advertise with us

Posted on Replacing knives on Ridgid Jointer ?

View Mainiac Matt 's profile

Mainiac Matt

8037 posts in 2325 days


#1 posted 06-13-2012 03:31 AM

With the out feed table lowered slightly below the level of the blades at top dead center, use the block of wood method KnotScott shows to get all the blades the same height (they’ll be the same height when they all drag the stick the same amount). Make sure you check the height at both sides of the blades.

Then raise up the out feed table untill it is at the same level as the blades at top dead center, and tighten up the gib lock screw to prevent the outfeed table from moving.

Set your depth indicator to zero and you should be good to go.

-- It’s the knowledge in your head, skill in your hands and motivation to create in you heart that makes you a woodworker. - Mainiac Matt


DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com