Reply by Dusty56

  • Advertise with us

Posted on Ridgid JP06101 infeed/outfeed tables not coplanar

View Dusty56's profile


11819 posts in 3716 days

#1 posted 05-21-2012 11:26 PM

With the spec’s shown in your diagram , I would think technique would be the cause . You’re at zero where the board enters and exits the knives , all the way to the end.If your knives are properly set , then that only leaves procedure.Your tables are almost 4’ wide , so that rules out unsupported material.

-- I'm absolutely positive that I couldn't be more uncertain!

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics