LumberJocks Woodworking Forum banner

Rip and glue or use as one piece?

1K views 5 replies 6 participants last post by  waho6o9 
#1 · (Edited by Moderator)
I have some wide maple boards for making raised panels in the kitchen. Is it safe to use these in one solid piece or should I rip them in half and glue them up? Someone told me it is better to rip them to relieve stress in the wood.

Thanks,
Rut
 
#3 ·
If they are nice and dry and flat and stable, go for it. If not, rip and glue back up. That way, you can get the ripped pieces perfectly flat on the jointer, then plane them to final thickness, and re-glue.
 
#5 ·
More than likely you will have doors as wide as 24" which means some panels will Have to be glued.

So, I like to think about the look of uniformity from one door to the next. I glue panels with 3 - 5 1/2" pieces (not all the same). Verify where the joints will land (not to close to routed profile)

Why take a chance of warping with a really wide board when it ends up looking different than the other doors?
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top