Reply by b2rtch

This is not my saw, I did not take pictures, but it is identical to mine, except that mine has the bottom door on and it has a short table extension on each side.

Did any one of you made a cover over the motor and installed an effective dust collection for this model of Unisaw?
I know that to make a cover would not be difficult.
Is a motor cover available from Delta? (I need to call them)
As for dust collection I would need to make a bottom and a shroud around the blade and to somehow to install a 4” inch connection.
This also should not be too difficult to make but did someone already made it?

About the fence, it seems to be very crude, it is the fence with tow chromed pipes and the fence itself has like a rack and pinion adjuster. It does not terribly easy to use nor accurate.
I ordered this fence on Amazon last night:
http://www.amazon.com/dp/B000022621/ref=pe_175190_21431760_A1_cs_sce_dp_1
as well a paddle switch and a Shark riving knife

I am still hesitating about the router table extension.
I like the Grizzly :
http://www.grizzly.com/products/Router-Extension-Table-for-Table-Saw/T10222

I ma also thinking about building one but the last one I built did not turn out too good. I think it may be easier and better to just buy one.

-- Bert