Reply by lunn

I also have a small craftsman jointer got so mad at it almost sent it to the junk pile !! Since i use sawmill lumber nothing i did came out right. Now i use it all the rime. Here’s how i do it. I run the wood through with the crown up getting the edge as close to flat as i can. Then through the table saw to size it. I do 2 or more pieces the same width. Stand it on the edge and square it, clamp it and run it through a planer till all the saw marks etc are gone. Smooooth edges and no problem with the top being out of square.

-- What started as a hobbie is now a full time JOB!