Reply by interpim

Posted on Zero clearance insert causing blade noise

1115 posts in 1627 days

#1 posted 430 days ago

The instructions for the insert I got on my saw says that if you are getting excessive noise from the insert to run a file through the kerf a few times to knock off a bit. With the little amount your removing from the kerf, it’s not going to cause issues with small pieces… Considering when was the last time you cut a piece that is only a few thousandths thick LOL…

-- San Diego, CA

Go to Pulse page »

LumberJocks Pulse

	Author	Latest activity		New comments or replies since you last checked
My Journey As A Scroll Saw Pattern Designer #1040: A "Divine" Lesson	Sheila Landry (scrol	11 seconds ago	by jerrells	sign in to get readership tracking
Library Cabinet	Les Hastings	2 minutes ago	by Roger Clark aka Rex	sign in to get readership tracking
Anyone use untinted base paint as a substitute for spar varnish?	dhazelton	4 minutes ago	by terdferguson	sign in to get readership tracking
LJ friends and gifts. #8: The postwoman came to my workshop... with a pack from a dear friend.	mafe	5 minutes ago		sign in to get readership tracking
Sketchup - Too Good To Be True	jack4002	8 minutes ago	by RonInOhio	sign in to get readership tracking
Where to find	TCCcabinetmaker	9 minutes ago	by Clint Searl	sign in to get readership tracking
terdferguson's Profile	terdferguson	10 minutes ago		sign in to get readership tracking
Shave Horse "The Clydesdale"	Beshires1	11 minutes ago	by BigDaddyO	sign in to get readership tracking
Lumber identification	Marcus	17 minutes ago	by Marcus	sign in to get readership tracking
My misadventures trying to buy a flat router table....	noone	17 minutes ago	by Farrout	sign in to get readership tracking

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics