LumberJocks Woodworking Forum banner

Mortise and tenon rule of thumb?

18K views 6 replies 5 participants last post by  Rick Dennington 
#1 · (Edited by Moderator)
I am getting ready to create several mortise and tenon joints. I was wondering if there was a "rule of thumb" when cutting these.
So for inctence my 4.5" rails are going across a 20" distance into 2" square legs. The rails are 3/4" thick. The question is what should my tenon dimensions be? I know once I have my tenon dimensions I can cut my mortise first then cut my tenons to fit tight. I also know I need extra material on the ends to allow for the tenons just not sure how much I should have.
 
#2 ·
Most rules or reccomendations I have seen suggest 1/3 the stock thickness. So, for 3/4" stock that would be 1/4". I agree with that and thats what I use for 3/4" into another 3/4" piece. In your situation, 3/4" into 2" stock, I would make my Tennon 3/8" or maybe even 1/2" if it needed extra strength; like for a long rail.

I try to make the length of my tennons 2 times their width. So, if you go 3/8" tennon, they would be 3/4" long. Again, this can change depending on the application. Like for pinned tennons, they have to be longer.

Note that if you have 1/2" tennons on two sides of a 2" leg and make them both 1" long, the ends will have to be mitered.
 
#3 ·
I agree with crank49 on his explanation of what needs to be done to mortise and tenons…..That's pretty much how I do all of mine with the stock you mentioned. Most of the time when I work with 3/4" stock, I normally do the 1/4" mortise and tenons…...One thing I've found….when I make the tenons 1" long, I usually have to shave them back to about 7/8",or a shade shorter to keep them from hitting each other… Sorry…I see that crank has already explaned that…..:)
 
#6 ·
I know this is a late entry and I agree with all of the above but would like to add:

The rule I use is to equalize the strength of the two peices. On 3/4 stock a good tenon width is 1/4, length 1 and 1/4 long if you can make that happen….but this is a rule for joining equal width peices. If you are joining a 3/4 peice of material into the face of some stock 3 inches wide, making the tenon thicker will increase the overal strength of the joint.

You should also factor in how you cut your mortise (for me, what size chisel I have on hand) and match your width to the closest tool you have on hand. I also factor the strength of the woods being joined, if I am putting hickory into poplar for instance, the tenon can be slimmer to equalize the strength of the peice.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top