LumberJocks

Reply by Belg1960

  • Advertise with us

Posted on table saw insert is tipping??

View Belg1960's profile

Belg1960

1072 posts in 3090 days


#1 posted 12-10-2016 06:44 PM


These are the posts that the plate rests on.


This is the original there is a small pin on the end that tip down and goes into nothing. It would stop the plate from tipping back.
As for my technique when using small stock I use this type of push stick.
Im liking the adding a piece on the rear, also on Kreg miter bars they have set screws in the sides to get a better fit might do that on one as well. Thanks for the info men.

-- ***Pat*** Rookie woodworker looking for an education!!!


DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com