LumberJocks

Reply by wichman3

  • Advertise with us

Posted on Problem with arbor nut and shaft on older Craftsman table saw. Need help!

View wichman3's profile

wichman3

62 posts in 585 days


#1 posted 12-03-2016 05:39 PM

Direct drive or pulley?
one way to get the nut off is to use a drill, a flex shaft adapter, a 3/8 socket drives and a socket that fits the nut. The the drill torsion to back the nut off the shaft. Then, clean up the threads on the shaft.

If you can remove the motor, carefully drill a hole in the end of the shaft (either end), tap the hole and install a bolt (head diameter less than the shaft diameter, a jam nut at the end of the bolt may be required to give enough surface so you’re not just rounding off a small bolt head) epoxy in place. Use the head of the nut to brace the shaft to remove/replace the arbor nut.


DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com