LumberJocks

Reply by wuzfuzde

  • Advertise with us

Posted on bandsaw cirle cutting jig

View wuzfuzde's profile

wuzfuzde

24 posts in 1397 days


#1 posted 08-28-2011 11:27 PM

Some progress has been made …not perfect but much better…. All thanks to you fellows imput.. My solution is re cutting my base board square… mounting the base board——use a square and from the rear lign the cutting edge of the blad with the center of the pin… apply a clamp on the side… gently push the pin rod into the running blade…. when it reaches the desired circe tighten the pin slider. and begin to cut and perhaps the most important lesson i learned was to——move ever so slightly the entire jig to the left or right… after the targeted circle is starting to operate correctly ..permantly tighten the side clamp/
Thank you for your suggestions Bill


DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com

Latest Projects | Latest Blog Entries | Latest Forum Topics

GardenTenders.com :: gardening showcase