Reply by 8iowa

  • Advertise with us

Posted on What's your favorite shelf pin drilling method?

View 8iowa's profile


1580 posts in 3759 days

#1 posted 07-11-2011 08:55 PM

I drill the holes in the sides before assembly of the case. First, I use a tape measure to mark the spacing 1” apart down the length of the side, then taking a combo square I mark the hole centers 2” in from front and rear.

Using the Shopsmith in drill press mode, I set the fence for the 2” spacing and “eyeball” each drilled hole, setting the stop so that I don’t drill all the way through. For long boards I use roller bearing stands to support the board on each end.

I find this method to be surprisingly accurate and quick.

-- "Heaven is North of the Bridge"

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics