LumberJocks

Reply by HorizontalMike

  • Advertise with us

Posted on How do you make plumb vertical holes, i.e. dog holes in a 4" thick bench top?

View HorizontalMike's profile (online now)

HorizontalMike

6925 posts in 1545 days


#1 posted 1229 days ago

Here you go Crank,
The Brad point bit with drill is the way to go.
http://www.horizontalheavens.com/GarageWorkshop/Projects/21stCenturyWorkBench/UsingDogHoleTemplate.jpg

http://www.horizontalheavens.com/GarageWorkshop/Projects/21stCenturyWorkBench/MakingDogHoleTemplate.jpg

Similar to Barry’s I’m sure, this is the template I used to drill all the dog holes in my 21st Century Workbench. I used scrap piece of 2” Ash and glued a 90d. fence on it for edge referencing. I also used a 1/2” hammer drill set to drill mode. NOTE—Do NOT forget to use a back plate to stop tear out on the exit side.

-- HorizontalMike -- "Woodpeckers understand..."


DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com

Latest Projects | Latest Blog Entries | Latest Forum Topics

GardenTenders.com :: gardening showcase