LumberJocks

Reply by opinionated

  • Advertise with us

Posted on Changing Bearings on a Table Saw

View opinionated's profile

opinionated

6 posts in 2920 days


#1 posted 01-29-2011 03:45 AM

Is it a left hand thread?
I would apply a propane torch to the nut to warm it up to about 250 degrees to soften the thread retaining compount that Delta must have used on this nut.
I have to say this is the first Delta arbor of this configurtion I have ever seen. I would also get the entire casting off the saw and clamp the pulley in the jaws of a vice, using wood protectors of course. this would allow you o use mor force if needed to remove the nut. I assume it still comes out by driving out a pin? Don’t lose the wavy washer that goes in the pivot joint.


DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com