LumberJocks

Reply by JBrow

  • Advertise with us

Posted on How do I make this joint?

View JBrow's profile

JBrow

1354 posts in 916 days


#1 posted 03-04-2016 05:55 AM

JK1972,

An approach to simplify the joinery is to cut rabbets on the top and bottom surfaces of the 4” x 4” stretchers at the joining ends, perhaps ¾” deep, creating tenons. Then cut two wide ¾” thick pieces to the outline of the three stretches. The ¾” profiled pieces would then fit into the top and bottom rabbets. The ¾” profiled pieces could then be flushed up with the stretchers. The grain direction of the top inlayed ¾” stock would be orientated perpendicular to the grain direction of the bottom inlayed ¾” pieces – for strength. The gap in the butt cuts on the tenoned ends of the stretchers would be concealed by the top and bottom ¾” inlays.


DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com