I recently ordered a Grizzly H8241 switch (http://grizzly.com/products/110V-Paddle-On-Off-Switch/H8241) for my router table and it arrived yeseterday. I'm a bit confused about how to wire it in, though. There were no instructions in the box and they didn't appear to have any online either.
On the back of the switch, there are four spade terminals, but I was only expecting to see two terminals like a standard household switch. I would only expect to see four terminals on a 220V switch or a double-pole switch? I searched the forum and found several people using this switch, but didn't see any info regarding wiring it.
Does anyone have any insight they care to share? I intend to investigate it using a multimeter when I get home later today, but instructions or first-hand advice tend to give me that warm and fuzzy your-house-isnt-going-to-burn-down-while-you-sleep feeling.
On the back of the switch, there are four spade terminals, but I was only expecting to see two terminals like a standard household switch. I would only expect to see four terminals on a 220V switch or a double-pole switch? I searched the forum and found several people using this switch, but didn't see any info regarding wiring it.
Does anyone have any insight they care to share? I intend to investigate it using a multimeter when I get home later today, but instructions or first-hand advice tend to give me that warm and fuzzy your-house-isnt-going-to-burn-down-while-you-sleep feeling.