LumberJocks

Reply by flatboarder

  • Advertise with us

Posted on Delta DJ30 12" Jointer

View flatboarder's profile

flatboarder

100 posts in 2853 days


#1 posted 10-20-2010 12:12 AM

Yeah your right I’m sorry about that I got the knives in as per the owners manual and It didn’t work so well. I got the knives within .002 of each other. When I made a cut It felt like it was banging on the bottom of the board. I think I need to raise the knives up to .030 above the locking bar ” GIB’ and then set the outfeed table according to that. The manual says to set the out feed table .015 above the cutterhead body so this it what I did. I’m using a OneWay Multi gauge with the flat tip. after I finnished setting everything up I then dropped the outfeed table .003 below the top of the knifes arc. Is this correct so far?

-- Ive cut this board three times and its still too short?


DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com