LumberJocks

Reply by SplinterDave

  • Advertise with us

Posted on joint advice

View SplinterDave's profile

SplinterDave

15 posts in 2444 days


#1 posted 02-03-2010 06:57 PM

Jim,

I am not sure if this would work but I might try using splines. Cut a slot in the small block and the angle pieces that join up along a similar line as what is shown in the picture from CharlieM1958. I’m not sure of the sizes of the pieces being joined but let say the block is a 2” square block. If so I’d use 1/4” thick spines about 3/4” deep into each piece. If one surface is exposed the slots would not go all the way through but if there is a top that would cover them I’d make the slot all the way through.

I’m a relatively new wood worker too so take this advise as a consideration and not as something from an expert.

SplinterDave


DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com

Latest Projects | Latest Blog Entries | Latest Forum Topics

GardenTenders.com :: gardening showcase