• Advertise with us

Posted on 31-255X Delta X5 18" x 36" Drum Sander-Discontinued by Delta

View JMACGUITARS's profile


7 posts in 3253 days

#1 posted 01-14-2010 04:30 AM

I purchased one on eBay for 200.00, good, bad, or indifferent I own it and cannot afford a better one. I build guitars and use it to thickness the top, back and sides, I have mine within .003” from left to right, however it does not stay there long so I do a lot of adjusting, the feed belt stays pretty much centered, One thing mystifies me – I will set the table to it’s lowest position, level the table – front to back , left to right, however when I raise it the out-feed side will go up at a slower rate than the in-feed side, so when the table is within .200” there is quite an angle to it, does anyone know if the gears are different from front (in-feed) to Back (out-feed) and this is part of the design.


DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics