I have an old Delta 1HP Shaper for sale or trade. From what I can read from the data plates it is a Delta/Milwaukee Model # 624210 or 62A210 1 HP 110V Single Voltage 110 V Reversible Capacitor Motor, S/N 97-5128 or 77-5128. It has a wheeled base, and has a old Formica table over the original.
I also have at least 10 pair if not more custom knives and a couple of holders. Some, need slight surface rust cleaned off of them.
I am getting rid of this because I do not have a use for it. I am the second owner, as my father bought it new some 40 years ago. He had the motor completely rebuilt, of which it only saw very limited use afterward. If I had to put a total cumulative time it was ran after being rebuilt, I would say barely 70 hours. I can not get any other details on the shaper cause my father died several years ago. I transported it from California to North Carolina, 8 years ago. I have turned it on, but have not used it. It draws to much current for my service, which is another reason why I do not use.
I can not do this shaper justice, by telling you about it. I have limited shop space and have a need for a 14 inch band saw, or some other tools.
I would like to get at least $350 for it, or trade it for a good 14 inch band saw or some other power tool.
I can provide pictures, I just do not have any at this moment.
I live in Aberdeen, NC, and I am sorry but I am unable to ship or transport the shaper. I wish I could, but I am limited.
As a reference I am about an hour and half south of Raleigh (75 miles), about 2 hours north of Charlotte, and 3 and half hours west of Wilmington.
I also have at least 10 pair if not more custom knives and a couple of holders. Some, need slight surface rust cleaned off of them.
I am getting rid of this because I do not have a use for it. I am the second owner, as my father bought it new some 40 years ago. He had the motor completely rebuilt, of which it only saw very limited use afterward. If I had to put a total cumulative time it was ran after being rebuilt, I would say barely 70 hours. I can not get any other details on the shaper cause my father died several years ago. I transported it from California to North Carolina, 8 years ago. I have turned it on, but have not used it. It draws to much current for my service, which is another reason why I do not use.
I can not do this shaper justice, by telling you about it. I have limited shop space and have a need for a 14 inch band saw, or some other tools.
I would like to get at least $350 for it, or trade it for a good 14 inch band saw or some other power tool.
I can provide pictures, I just do not have any at this moment.
I live in Aberdeen, NC, and I am sorry but I am unable to ship or transport the shaper. I wish I could, but I am limited.
As a reference I am about an hour and half south of Raleigh (75 miles), about 2 hours north of Charlotte, and 3 and half hours west of Wilmington.