LumberJocks

First Project With the New Powermatic Table Saw #26: Slab is cured

  • Advertise with us
Blog entry by psient posted 497 days ago 613 reads 0 times favorited 0 comments Add to Favorites Watch
« Part 25: progress: STAGE 4 Part 26 of First Project With the New Powermatic Table Saw series Part 27: Water for the slab »

It’s been near a month since the slab was poured. At 30 days I am ready to seal the concrete. In the mean time I have pulled the electrical for 220 and 120 single phase circuits.

My electrical run consists of 3 different wire gauges; 6, 8, and 10. I can distribute varying amperage up to 50 amps. Mostly this is for convenience. The only real demanding tool I will routinely use is my big ESAB welder. Everything else will be 30 amps and below.

The 125 amp – 24 circuit sub panel for this run is in my garage. I ordered the 125 breaker for my main panel over a week ago but it as yet has not arrived. As soon as it does I’ll install, wire, and energize my sub panel.



0 comments so far

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com

Latest Projects | Latest Blog Entries | Latest Forum Topics

GardenTenders.com :: gardening showcase