|Project by Andy||posted 03-27-2014 10:55 PM||2120 views||5 times favorited||44 comments|
This was made for Trish, a good friend who needed a replacement for her old in-cabinet model.
I just snapped a quick picture so I could remember the pattern.
It fits in a slot in the base cabinet, the walnut front edge is curved and hangs below the board which serves as a finger pull.
The size is 15’’ wide x 21’’ deep x 3/4’’ thick.
It has a bees wax and mineral oil finish.
The woods are:
Center is claro walnut with a sweeping strip of maple.
To each side is myrtle wood
The two strips of blocks are wenge, paduak and maple.
Other woods are walnut, jatoba, wenge, cherry, maple, myrtle.
The bread board end is quarter sawn white oak and the pins are bloodwood.
Thanks for looking.
-- If I can do it, so can you.