|Project by jordanp||posted 02-12-2014 02:47 AM||1434 views||0 times favorited||12 comments|
Very simple little project that was requested by my lovely wife.
I cut a small bead along the top edge of the two ends with a Stanley #45. The curve on the sides were cut out with a jig saw. Just the most basic butt joint.
Used a 7/8” Forster bit for the finger holes.
Rough sanded with 100 grit and put a mixture of equal parts minwax red mahogany stain, BlO, mineral spirits. Then sanded to 220 and re applied the mixture and sealed with a can of satin spray on lacquer.
-- J. Palmer Woodworks - Rockwall TX -I woke up this morning thinking “man, I really hope someone posted some soul scarring sh*t on LJs today.” -- - Billy