LumberJocks Woodworking Forum banner

Project Information

This was my 1st hack at an endgrain cutting board. I was originally going for pic #3 but figured before I started spreading glue I'd check my other options. It turned out to be 10 1/2" x 16 1/2" and just under 1 1/2' thick. didn't get a pic of it but I put a half inch finger groove in the center of the sides. Its hard maple and walnut.

Gallery

Comments

· Registered
Joined
·
709 Posts
Cool pattern. How many coats of Mineral oil did you put on it?
 

· Registered
Joined
·
307 Posts
Welcome to the CB club. You designed a great CB.
-don
 

· Registered
Joined
·
4,477 Posts
I LIKE pic #3! You should do another in that pattern.
 

· Registered
Joined
·
2 Posts
Thanks nobuckle. Ended up with 4 coats of mineral oil. It actually blead oil for 2 days after I brought it into the house. I guess once it warmed up…
Joe I fully intend to try the original design too.
 
Top